The AC Infinity Cloudforge T3 is a 6 litre plant humidifier built to hold a target rather than just add moisture, and this generation adds optional auto-refill. A gravity-fed valve under the lid connects to an external water reservoir, so the tank tops itself up and runtime stretches from days to weeks or months. An EC ultrasonic vaporiser gives 10 levels of PWM output, a corded probe lets it hold a humidity or VPD target, and an AI mode fine-tunes output in small steps to keep the reading steady. Quick Bloom Lights is the official Australian importer: stocked in Sydney, 240 V Australian model with an Australian plug fitted, 2-year warranty handled here.
Intelligent controls
A household humidifier runs to its own internal setting with no idea what your extraction fan is doing. The T3 reads conditions through a 3.66 m (12 ft) corded probe placed where your plants are, then works to the number you set. Toggle the display between humidity and VPD and set the target for either: VPD accounts for temperature as well as humidity, so it reflects what the plant is actually dealing with.
Switch on AI mode and the adaptive programming ramps output up and down in small percentage steps as the reading drifts from target, rather than cycling between fully on and fully off. Auto-start with backup memory resumes your settings after a power interruption, and the UIS port is sealed against water.
Optional auto-refill: grow longer, refill less
The 6 L tank runs over 66 hours on its own (AC Infinity's figure). For longer, twist the included auto-fill valve onto the bottom of the lid, run the 2.1 m (7 ft) vinyl water tube from the lid nozzle to an external reservoir, and the valve keeps the tank topped up. AC Infinity rate this at around 550 hours from a 50 L reservoir and around 2,497 hours from a 230 L reservoir, which is roughly four months between refills.
It is gravity fed, so the reservoir must sit higher than the humidifier for a continuous flow. The reservoir itself is not included; any clean container that can sit above the unit will do. You can still fill the tank by hand through the lid panel whenever you prefer.
Targeted moisture
Swap the directional flow cap for the included flexible hose, which extends from 73 cm to 210 cm (28.7 to 82.7 in), and moisture goes exactly where you want it. Because the probe is corded and the hose is long, the T3 can sit outside the tent with only the hose feeding in: the tank stays easy to reach, the footprint stays out of your grow space, and readings still come from inside.
Route the hose upwards to the highest duct port and keep it sloping up the whole way. A U-bend or a downward slope lets condensation pool, which blocks the mist and can drip back into the base.
Full specifications
| Manufacturer | AC Infinity Inc. |
| Product / model | CLOUDFORGE T3 / AC-CFT3 |
| UPC | 819137023611 |
| Dimensions | 20.9 × 16.9 × 38.5 cm (8.22 × 6.65 × 15.15 in) |
| Tank capacity | 6 L (1.5 gal) |
| Runtime | 66 hours per fill (AC Infinity rating); continuous with auto-refill |
| Output rate | 300 ml/h (10.1 fl oz/h) at full output |
| Output levels | 10-level PWM, EC ultrasonic vaporiser |
| Noise | 32 dBA |
| Power | 28 W |
| Voltage / frequency | 240 V AC / 50 Hz (Australian model) |
| Power connection | Australian three-pin plug |
| Operating temperature | 5 to 50 °C (41 to 122 °F) |
| Operating humidity | 30 to 85% RH |
| Flexible hose | 73 to 210 cm (28.7 to 82.7 in) |
| Auto-refill water tube | 210 cm (7 ft) vinyl, gravity fed; reservoir not included |
| Sensor probe | 366 cm (12 ft), humidity and VPD |
| Onboard programs | Humidity target, VPD target, ON mode, AI adaptive mode; timers, cycles and schedules via UIS controller |
| Safety | Pauses when the tank is empty or removed, or if tilted past 45° |
| In the box | Humidifier, sensor probe, flexible hose, auto-fill valve, water tube, UIS extension cord (M-M), nebuliser brush, wire tie, hook and loop tie |
| Quick start guide | Download PDF (setup, auto-refill, programming, cleaning) |
FAQ
What changed from the previous T3?
The tank went from 4.5 L to 6 L, output from 240 to 300 ml/h, and noise dropped from 38 to 32 dBA. It adds the gravity-fed auto-refill valve, an AI adaptive mode, a longer adjustable hose and a UIS extension cord in the box. The onboard controls are simpler: humidity or VPD target, ON mode and AI mode on the unit, with timers and cycles now handled by a UIS controller.
How does the auto-refill work?
Twist the auto-fill valve onto the bottom of the lid until it locks, then connect the 2.1 m water tube from the lid nozzle to your reservoir. Place the reservoir higher than the humidifier and gravity does the rest; the valve lets water in as the tank level drops. No pump and no extra power are needed.
How long does a tank last?
AC Infinity rate the 6 L tank at over 66 hours. At full output (300 ml/h) it empties in about 20 hours, but under closed-loop control it only produces mist when the space needs it, so real runtime sits well above that. With a reservoir connected, a 50 L tank gives around 550 hours and a 230 L tank around 2,497 hours.
Tap water or distilled?
AC Infinity recommend distilled water to reduce mineral build-up; RO water works the same way. Ultrasonic humidifiers atomise whatever is in the water, so tap water minerals end up as fine white dust on leaves and surfaces and as scale inside the unit. Change the water at least every 4 days and clean the nebuliser and filter weekly with the included brush.
Do I need a controller?
No. The onboard controls hold a humidity or VPD target on their own using the included probe. A UIS controller adds timers, cycles, schedules, app access and data logging, and brings the humidifier under shared programming with your fan and heater. It is worth it once several devices share one space.
T3 or T7: which size do I need?
The T3 suits tents and smaller spaces; the 15 L T7 suits larger tents and full rooms with roughly four times the output. With auto-refill connected, refilling stops being the deciding factor, so choose on output: if a T3 would run near its top level most of the time, size up.
Will it fight my extraction fan?
If both run blind, yes: you will humidify air that is immediately pulled out. Running both on one UIS controller solves it properly, so the fan and humidifier work toward the same target. Standalone, aim the hose into the path of a circulation fan rather than straight at the plants, and avoid over-extracting.
Is this a genuine AC Infinity unit with Australian warranty?
Yes. Quick Bloom Lights is the official Australian importer and distributor for AC Infinity. Every unit is the 240 V Australian model, ships with a fitted Australian plug and carries a 2-year warranty handled here in Sydney. No sending units overseas, and no dealing with an offshore seller if something goes wrong.